Starter Field Coil Soldering

Posted by Neil MacGregor on May 14, 1998 at 10:46:30

I separated the field coils to rewrap them.Now I have to resolder them.But, I'm concerned about burning up my new wrappings as I attempt to reconnect the links.I'm using a small pinpoint propane torch since I need a sizable heat source to get them hot enough to solder.I need some type of heat sink/shield to protect the the wrappings.There is not a lot of room work with.Has anyone out there done this?How?
Many thanks for your input/experience.

Neil


Follow Ups:



Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam