Re: Starter Field Coil Soldering

Posted by Jack Richard on May 14, 1998 at 13:54:45

In Reply to: Starter Field Coil Soldering
posted by Neil MacGregor on May 14, 1998 at 10:46:30

I would think you could use a good soldering iron to solder the coil wires together. I would not use a torch as you could burn the wrappings and also melt the wire coating which insulates the turns from one another.Good luck.
: I separated the field coils to rewrap them.Now I have to resolder them.But, I'm concerned about burning up my new wrappings as I attempt to reconnect the links.I'm using a small pinpoint propane torch since I need a sizable heat source to get them hot enough to solder.I need some type of heat sink/shield to protect the the wrappings.There is not a lot of room work with.Has anyone out there done this?How?
: Many thanks for your input/experience.
: Neil

Follow Ups:
Re: Starter Field Coil Soldering Ben Jenkinson May 14, 1998 at 20:03:56(0)
Re: Starter Field Coil Soldering Ben Jenkinson May 14, 1998 at 20:03:59(0)

E-Mail Comment to Webmaster