setting timing

Posted by Jack Metcalf on July 22, 1998 at 19:42:13

I know this question has been asked before but how do you
set the timing on an "A".It is usually said that when the
pin goes into the indent in the timing gear the rotor
should be pointing at electrode for #1.Which part of the
rotor since it is several times wider than electrode? What if
the indent on timing gear is so shallow that your not sure
if youve found the spot (as mine is)? It seems to me I heard
somewhere of using a test lamp at the points after this.How
is this done?
Thanx in advance.....Jack

Follow Ups:



Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam