Posted by DJ. Voyce on July 31, 1997 at 13:48:27
In Reply to: TAIL LIGHT MOUNTING POSITION
posted by Tony Parisi on July 29, 1997 at 14:43:24
: I recently installed steel after market rear fenders on my 30 TUDOR sedan, but there were no holes punched for mounting the tail lights.Can anyone give me the measurements (rear to front) from the rear bottom edge of the fenders to the tail light mounting bolt holes.Also the measurements (side to side) from the wheel openening edge to the bolt holes. A measurement taken with a flexible tape measure would be best. G'Day Tony Top hole centre 236mm from edge of fender & 459mm from bottom |
Follow Ups:
|