Re: TAIL LIGHT MOUNTING POSITION

Posted by Tony Parisi on August 03, 1997 at 18:08:43

In Reply to: Re: TAIL LIGHT MOUNTING POSITION
posted by DJ. Voyce on July 31, 1997 at 13:48:27

: : I recently installed steel after market rear fenders on my 30 TUDOR sedan, but there were no holes punched for mounting the tail lights.Can anyone give me the measurements (rear to front) from the rear bottom edge of the fenders to the tail light mounting bolt holes.Also the measurements (side to side) from the wheel openening edge to the bolt holes. A measurement taken with a flexible tape measure would be best.
: G'Day Tony

:My Town-Sedan back-end is standing outside my office at the moment with the rear fenders on but no tail light mount so if you've got a metric tape you can compare these measurements from the RH side with Rick's when you get them.
: Top hole centre 236mm from edge of fender & 459mm from bottom
: Bottom RT centre 198mm from edge of fender & 415mm from bottom
: Bottom LH centre 271mm from edge of fender & 405mm from bottom (this one's a bit hard to measure with the curve on the bottom of the fender)
: Large hole centre for wires 235mm from edge of fender & 436mm from bottom (1" dia. 25.4mm)
: Regardz
: DJ.
D.J.
Thanks.Its pretty easy to make theconversion.
tp

E-Mail Comment to Webmaster