A question of vintage-

Posted by Bob Carabbio on July 28, 1997 at 20:34:39

Since my flywheel housing was cracked in the usual places, I picked up a replacement unit locally which was intact, but different in that there are 4 ribs cast into the outer surface which run forward from the bell-housing bolts, (the two center ribs coinciding with the two bottom bell-housing bolts) and end at the front surface of the housing.

My "original" housing was smooth on its under surface.The illustrations in Page's book indicate that '28 flywheel housings were also smooth.

Does anyone have an Idea when these features were added??
I don't find any reference in the service bulletins.

Bob Carabbio


Follow Ups:



Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam