Re: CB radio installation

Posted by Jack Richard on April 08, 1997 at 00:29:36

In Reply to: Re: CB radio installation
posted by Larry Jenkins on April 07, 1997 at 17:30:13

My CB is fairly small Radio Shack model, and I removed the cardboard panel first, mounted the standard bracket it came with on the panel with small machine screws and large washers inside the cardboard to help prevent tearing.I ran the antenna wire under the front carpet along the passenger side to the rumble are, then across to the left-rear corner of the boldy, out a small hole to the antenna.The remote mike mount was from Radio Shack - I drilled a hole in it and mounted it on the lower right instrument panel screw.Good Luck!

Follow Ups:
Re: CB radio installation doug linden April 08, 1997 at 12:26:43(0)

E-Mail Comment to Webmaster