Re: Black oxide fender edge bolts

Posted by Rick Black on March 24, 1997 at 13:49:11

In Reply to: Black oxide fender edge bolts
posted by Ken Smith on March 24, 1997 at 13:37:10

If you're planning to show your car under MAFCA/MARC judging guidelines, take a look at the section about fenders and see if those bolts are specifically mentioned.
----
On building my show '31 Tudor, I consulted the book "Model A Chassis Parts" extensively for bolt/fastener finishes.For your example, I'd look up FRONT FENDERS and then find the bracket part number.Right under that, Ford listed the bolts, washers, nuts, cotters needed.The part number of each of these usually have a suffix, like -S1.There's a table in the book that lists each suffix and the finish that was originally on the part.
-----
If you need further clarification, I'd suggest you write to the MAFCA Technical Director - his e-mail is: modasvc@aol.com
and ask him the same question.He can pass it on to the Judging Standards committee if he doesn't know.
-----
Regards,
Rick

Follow Ups:
Re: Black oxide fender edge bolts Larry Jenkins March 24, 1997 at 15:45:13(3)
Re: Black oxide fender edge bolts Dave Colliau March 29, 1997 at 18:29:15(1)
Re: Black oxide fender edge bolts Larry Jenkins April 01, 1997 at 21:09:05(0)
Re: Black oxide fender edge bolts Dave Colliau March 29, 1997 at 18:26:34(0)

E-Mail Comment to Webmaster