Posted by DJ.Voyce on July 21, 1998 at 00:52:52
In Reply to: Lub question on throwout bearing slider
posted by James Shotwell on July 20, 1998 at 23:13:37
G'Day James, The good news is you have to lift up the floor board, but the cover that provides access to the throwout bearing is the square one on the bell housing with the little louvres in it. Loosen the two screws & it should just slide off then you'll see the bearing. Regardz DJ. OutOfAfrica A's : I am a new model A owner and I am trying to do a complete lub |