Re: Front Motor Mount

Posted by Steve Leonard on July 20, 1998 at 11:47:55

In Reply to: Re: Front Motor Mount
posted by Kevin Daly on July 20, 1998 at 10:07:07

: Steve, : You have the wrong engine mount.Both Snyder's (330)549-5313 and Bratton's (301)253-1929 have diagrams and replacement kits virtually identical to the original setup (3 coil & 1 flat spring6 Bucks!).I had a system the same as the one you describe and the rubber mounts were as hard as a rock.I replaced it with the kit and the springs offer better support and shock absorption.If your not replacing your's,there's a castle nut under the front cross member to adjust the front tilt up or down. I you loosen it and the front doesn't come up, you may need a replacement system as your rubber mounts may have taken a set in their current position. : Good Luck, : Kevin Daly Thanks Kevin I thought there was something not right about it. It certainly made it hard to get leverage when using the hand crank. Do you know where that mount originated from? Steve

Follow Ups: Re: Front Motor Mount Kevin Daly July 20, 1998 at 12:36:05(0)

Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam