Posted by Kevin Daly on July 20, 1998 at 10:07:07
In Reply to: Front Motor Mount
posted by Steve Leonard on July 20, 1998 at 08:14:00
Steve, You have the wrong engine mount.Both Snyder's (330)549-5313 and Bratton's (301)253-1929 have diagrams and replacement kits virtually identical to the original setup (3 coil & 1 flat spring6 Bucks!).I had a system the same as the one you describe and the rubber mounts were as hard as a rock.I replaced it with the kit and the springs offer better support and shock absorption.If your not replacing your's,there's a castle nut under the front cross member to adjust the front tilt up or down. I you loosen it and the front doesn't come up, you may need a replacement system as your rubber mounts may have taken a set in their current position. Good Luck, Kevin Daly |
Follow Ups:
|