Re: Manifold Installation

Posted by Glen Weilbaker on July 06, 1998 at 07:49:18

In Reply to: Manifold Installation
posted by John Talbourdet on July 06, 1998 at 06:32:02

John,
The copper clads are good to use but do require retorque after engine warm up just as the head gasket. The final torque is 50ftlbs. Start with 20 and work up with 10lbs incriments begining with the center most nuts working out. After the engine comes up to temp after a few minutes, while hot retorque the same as cold. May have to be done a couple of times til the gasket takes a set.
Good luck,
GW

E-Mail Comment to Webmaster