Re: spindle bolt

Re: spindle bolt - More!

Posted by Marco on April 13, 1998 at 11:54:03

In Reply to: Re: spindle bolt
posted by Marco Tahtaras on April 12, 1998 at 23:26:43

I was discussing the topic with a friend and he mentioned experience with front axels that had one end of the locking pin hole burred from the tightening of the nut and lock washer. The locking pin should slide through the hole and out the other side with no spindle bolt in place. If it won't slide through, the hole must be deburred.

E-Mail Comment to Webmaster