Posted by Jerry Murray on April 06, 1998 at 21:08:22
I would like to remove the old Clutch Throw Out Bearing from the release bearing hub. The old one is extreamly tight should I use a press? or is there a secret. The old bearing feels OK except for embedded grit. I am sure I could clean it satisfactory, but don't know how I would regrease the bearing. Also any thoughts on how to regrease the Pilot Bearing in the center of the flywheel. thanks in advance for the advice. I am doing a complete restoration on a 31 SW, Town Sedan, Model 160-B. |
Follow Ups:
|