Posted by Ben Jenkinson on Sep. 13, 1998 at 20:51:58
In Reply to: Cutouts with Diodes - how is it done?
posted by Steve Mick on September 12, 1998 at 22:34:38
Hi Steve, Let me tell you what I did about twenty years ago and it is still working fine. I took the diode block out of a GM alternator(junk one,prior to the built in regulator)and cut a section of the block off with a saw.(the section holds one diode) I drilled and tappped two 8/32 holes in the block(the block is a heat sink)and made a small bracket to hold the block in the cutout housing.I've never experiensed any problems and it is a cheap fix. Best of luck,Ben Jenkinson |