Follow up : Stuck rachet nut "success"

Posted by Alex Spyksma on September 09, 1998 at 20:20:58

In Reply to: Re: Stuck rachet nut
posted by H. L. Chauvin on September 08, 1998 at 22:23:55

How we got the rachet nut off(Glenn's son)
1.Carefully brook off round belt groove around spokeson pulley with ball hammer.
2. Used a grinding wheel cut off the rest of the cast iron pulley.Took a chisel and broke the remaining pieces out.
3.With a borrowed wrench (from my carpenter friends) one strike of the nut and it spun off easily.
It goes to show again that a little instruction and patience goes a long way.Also it is important to remember where to get tools when you need them.A good tool is worth a lot.
Thanks again.Glenn