Re: Help removing distributor/shaft

Posted by Bob Johnson on January 06, 1998 at 09:33:02

In Reply to: Help removing distributor/shaft
posted by Dan Waterhouse on January 06, 1998 at 08:33:13

Dan,

Try penetrating spray all around the bottom of the distributor.Remove the 'jam nut' completely and spray into the hole.There should be a pin on the bottom of the distributor that goes into a hole on the top of the head.This pin prevents the distributor from rotating.So do not try to rotate the distributor to get it out.Try using a screwdriver between the distributor and the head to pry it up.Once the pin is clear of the head you can rotate the distributor to remove it.Be careful not to bang on the distributor too hard since it is cast metal and can break.

Bob


Follow Ups:



Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam