Posted by Paul Koncak on August 24, 1997 at 20:44:05
In Reply to: Loose two-piece crankshaft pulley
posted by Bill Hartmann on August 24, 1997 at 19:26:48
: I just discovered my two-part crankshaft pulley is loose on my 29 Coupe. The large socket I have won't fit while the engine is : in the car.I tried tightening it with the crank, but it didn't budge.Any suggestions short of removing the engine to tighten it?? A little hard to get at, isn't it Bill!?I have tightned them with a big punch and hammer but it can be a little hard on the radiator if you miss.The suppliers sell a wrench that will work ok!.. provided that you have the proper size nut on it.I bought one of the wrenches.It was made using a HEX 1 3/8" socket.The socket (1 3/4" deep) has two adjoing flats sawded off so that the wrench can be put on the nut. A piece of 1 1/2" flat stock was welded to the top edge of the socket for a handle.The handle is 15" long with a 1 3/4" offset 4 1/2" from the socket.The offset is bent so that the long shank of the handle is in line with the face of the socket. |
Follow Ups:
|