Re: Wanted: Engine Tooling

Posted by John Cannon on May 21, 1997 at 12:10:02

In Reply to: Wanted: Engine Tooling
posted by John de Sousa on May 20, 1997 at 11:33:42

: Looking for the following Engine Tooling: Thrust Bearing Cutter; Rod Lathe; Rod Molds; Cap Molds; Oil Groove Cutter; and Pouring Molds for the Mains. Any help would be appreciated.
John, I have been seeking the tooling you are looking for for several years.It is hard to find.I have found some through ads in Hemmings Motor News and various flea markets.Try the April & May issues of Hemmings.I believe there was some offered in the '03-'31 Ford parts section.Also, there is a fellow named Tom Godish (sp?) who operates the Model A Ford Works in Portland, Oregon who reproduces some tooling such as the grove cutters.It is not cheap, but is good stuff. E-Mail me if I can help with this.Good Luck! John Cannon

Follow Ups:
Re: Wanted: Engine Tooling John de Sousa May 28, 1997 at 11:34:11(1)
Re: Wanted: Engine Tooling John Cannon July 24, 1997 at 11:50:55(0)

E-Mail Comment to Webmaster