Posted by Bob Johnson on March 06, 1997 at 10:49:42
In Reply to: Door hinge pin removal
posted by Ed Greany on March 06, 1997 at 00:50:36
Ed, I used a C clamp to remove door hinge pins. I put a small wrench scocket on the top side of the pin and used a nail or screw on the bottom. The nail should almost the same diameter as the pin.Also cut the nail (screw) so it is less than 1/4 inch long (otherwise it will not stay up and down when the clamp is closed). Use a nail or screw with a large head (also helps keep the nail from flipping). As you tighten the C clamp the pin should be pushed into the scocket. Bob |