Re: BODY BLOCKS

Posted by Joe Grobleski on Oct. 22, 1998 at 09:17:13

In Reply to: BODY BLOCKS
posted by J FLYNN on Oct. 21, 1998 at 18:56:30

Your kit should consist of a TOTAL of seven blocks.
Starting from the rear of the frame the block is three inches long and the taper goes to the outside of the frame.
The next block attachs to the frame sitting side to side and measures six inches long and the flat part of the block that measures three inches goes up and towards the inside of the frame. This block goes in the fifth hole from the rear on the frame.
The next block is the long piece and goes under the metal cross piece in the body then attachs to the sisth hole from the rear on the frame. Two of the holes need to line up with the two holes in this cross piece so the seat supports can be attached.
Finally the last block is attached with two bolts at the little tab that sticks out of the frame. The raised portion of that block goes to the rear of the car and like I said attachs with the two bolts at the base of the front door post.
Sorry to be so long but I hope that helps you.
Joe Grobleski
The Cape Codder

E-Mail Comment to Webmaster