Re: Brake or Broke? You Tell Me!

Posted by Ed J on Oct. 16, 1998 at 18:39:24

In Reply to: Brake or Broke? You Tell Me!
posted by Kevin Daly on Oct. 16, 1998 at 08:15:01

: Hi Folks,

: Well I guess you have all had enough time to polish, paint and bolt on all of the treasures you found at Hershey, so lets get back to the board, shall we?

: I recently purchased some items from a fellow board member. Specifically a king pin rebuild kit and a complete set of service brake shoe linings. Everything arrived yesterday and I was ready to get to work. Although the king pin kit is great, the brake shoe linings have me a bit puzzled. The linings are not the typical soft woven type, but a preshaped hard lining that is kind of coffee colored. (1 cream) Get the picture? They do have a what looks to be a steel wire mesh molded into them but are quite different from the stiff but plyable shoes with brass mesh that are on the car currently. What gives?

: Are these the bendix ones that rivet on like the woven linings. After all the set did come with new rivets. I have heard that these linings will not stop the car well and tear up the steel drums. I suspect they also may have asbestos in them but I'm not sure. Are they worthy of mounting?

: Also on a different note, The lower bushing hole in one of my spindle is elongated allowing me to push in the bushing with my thumb. I doesn't rock but under load I'm sure it will move. Any options for repair or should I simply find a replacement?

: By the way, I don't mean to imply the person I bought these items from was in any way dishonest. He and I discussed the parts at length on the phone and he answeres all of my questions concerning the parts. I guess I should've asked a few more questions. It was just a simple misunderstanding. The price was great and I still came out ahead in the end. So if he's reading this, no sweat, We'll just chalk it up to experience. Thanks in advance to you all for any answers.

: Regards,

: Kevin Daly

: PS. Is it proper to oil the king pin felts in the steel cup or leave them dry? I know, I know, too many questions!

....... rivet only if they have rivets with them and pre drilled and counterset holes in lining for the rivets........ The lining you have will probably be ok but take nore time to wear in. If it's not bucks I'd use the regular stuff .. save time in long run... The egg shaped hole for bushing I take it you mean where king pin goes thru bottom of spindle assy ?? If that is where your trbl is why not get good used spindle? I'm sure you can find locally or if not call me at 614-882-6851.. OH YES be sure to arc the shoes to drums.Usually the relined shoes will have a tighter arc than the drum. If that's so all you have to do is stretch the spine of the shoe ie that part 90 degrees to the outer rim by laying it on anvil or large vise and beating it with big hammer in 3 or 4 places along spine. Bot ! thats not very clear is it . oh well u got my #.. Ed....




Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam