Posted by Marco on July 27, 1998 at 22:32:56
In Reply to: A R U-JOINT lubrication
posted by Franz Lynch on July 27, 1998 at 22:08:48
: I have an early roadster pickup which does not appear to have : a grease fitting for the u-joint.Does someone know if this : is sealed with oil in it or is there a way to get grease in : there?Thanks ---------------------------- Franz, The A-7085 transmission main shaft bearing retainer (at the rear of the trans) doubles as the front half of the u-loint housing.From the beginning of production Ford installed a fitting (1/8" pipe thread) in this casting.If the retainer was installed upside-down you will have to remove the lower floor board for access. |