Re: Coupe spare tire support: image #3

Posted by Marco on July 07, 1998 at 01:40:25

In Reply to: Re: Coupe spare tire support: image #2
posted by Marco on July 07, 1998 at 01:26:26

The last photo shows the forming of the curved panel near the top of the riveted brace.

As mentioned earlier, shortening the rear vertical bracket shouldn't be difficult and should be done and installed first.Be sure it is snug against the outer panel so the panel won't draw inward when mounting the tire carrier.Second, bolt the curved panel in place and then fit the curved brace into place.

A little patience and imagination and you'll have a rear spare that won't bounce around when you drive down the road!

Good luck




Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam