Posted by Jerry Brenton on July 05, 1998 at 19:57:42
In Reply to: Re: proper dimentions for PUbed wood
posted by Robert Coker on July 05, 1998 at 06:58:17
: : I need the proper sizes to make new wood floor on 29 closed cab pickup. Any help would be appreciated. : one easy method: measure from either side of the inside of the bed to the first hole in a cross member and subtract 1/8".then measure center to center on remaining holes and subtract 1/4"this will get you the width of the board. the lenght should not be a problem. Thanks Robert Cocker. I measured as suggested before posting this but didn't know how much room to leave for the bolts and underside clips. This will help a lot. |