Re: Sedan Rear Floor Pans

Posted by Pat Patterson on April 04, 1998 at 09:54:10

In Reply to: Re: Sedan Rear Floor Pans
posted by Duane Storch on April 03, 1998 at 21:52:32

Thanks, much for the reply.Could I possibly get the measurements of the one you have?Is it for the Murray or the Briggs?I believe the one I have will work, but if the Murray version is a different length or width it'll throw my cross-sills off.
I bought a floor pan yesterday for the Briggs, hoping it was the same one as on the Murray (it was only $50 with minimal rust, and I've been looking for one forever...).But I notice the body bolt cut-outs don't line up when I place it in the car.Also, someone re-did the wood sub-frame at one time and placed a rear cross-sill in the back where it doesn't belong, installed the front and center cross sills at a slight angle (so he cut the front floor board at an angle to fit), and installed the front seat rail assembly backwards so the seat adjuster wouldn't fit.
Oh well.I wanted a project to work on, and it's been fun.Now I have to work from the back of the car forwards (with the correct seat pan) to determine where the cross sills go.And I have to determine where theseat rail assembly mounts on the frame.
I appreciate your help,
Pat

E-Mail Comment to Webmaster