Posted by Bob Carabbio on March 26, 1998 at 12:27:25
In Reply to: Re: Wheel Bearings
posted by Joe on March 26, 1998 at 07:07:21
Right on - the ID of the rear bearings is the same '28-'48 but the OD of 39-48 hubs is smaller so you'd have to use V-8 bearings and seals instead of "A" units on the rear. As stated the fronts are the same. MAKE SURE on the front that the outer end of the spindle where the smaller bearing fits is a good fit with the inner diameter of the bearing.A LOT of spindles have been damaged by the inner turning on the shaft and wearing the end of the spindle too small.ANY looseness here is too much. |