Posted by Fred Engelman on September 08, 1998 at 13:38:22
In Reply to: Re: QMI Gear Treatment
posted by Kevin Daly on September 08, 1998 at 11:19:17
: Kevin Daly I don't have any experience with QMI either but I do with Duralube.I watched when duralube was added to a freshly cut babbit bearing and it disappeared into the babbit like an oilite casting.I have started four car with duralube and I feel it does a good job.Another friend is adding it to tranny, rear end and crank case but I can't see the potential gain for this aditive.. |