Re: Wanted: 3-Speed Transmission housing for my Tudor

Posted by Bryan Espenschied on January 24, 1997 at 14:57:02

In Reply to: Re: Wanted: 3-Speed Transmission housing for my Tudor
posted by John Icenhower on January 23, 1997 at 17:55:24

: : After checking into the cause of some transmission noise in my 31 Tudor I see I have some trouble. The cast lip on the front opening of the transmission (that portion that houses the main shaft bearing) has broken and the front main shaft bearing retainer ring has been damaged. I have traced the cause of this damage to a broken rear motor mount that must have put pressure on the transmission's front main bearing. I have repaired the motor mount and have inspected all of the transmission components which are in very good condition. However, to make a long story short, I can not repair the damaged transmission housing as the casting is too badly damaged. I am in need of another housing. Do you or someone you may know have a spare housing or an old parts tranny that you/they would part with? A response or any leads would be appreciated.

: Are you looking for the actual gear case or the bell (clutch) housing. I think I've got an empty gear case but not a clutch housing. Send an e-mail with your locale.
: John

I have the parts in Salt Lake City, if that is closer
Bryan E-mail at estc@utw.com



Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam