Re: Flywheel ring gear

Posted by Rick Derksen on January 07, 1997 at 16:44:32

In Reply to: Re: Flywheel ring gear
posted by Don Harrington on January 05, 1997 at 17:08:35

I used a hydraulic press. Support it by the ring gear and put pressure
on the fly wheel close to one edge not the center. Tap with
hammer on fw til you see movement. Relaese pressure, turn a quarter
turn and repeat. Eventually one side will pop off so be carefull.
dont worry about bending it it is very resilliant at least the
originals are.



Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam