: I haveBoyce temp gauge that mounts on the sterring column. It needs a special head bolt ot attach to. I need on or would like to borrow one to make a pattern. Homne phone (503)838-0026. Brian, I have a Boyce meter such as you describe on one of my cars.While I do not have an extra Accessory Nut(headbolt), I have measured the one in use.It is made of 3/4" hex stock.Overall length is 2 9/16".The bottom is drilled and tapped to 7/16x20 to fit the Head stud.The top end is machined down 9/16" to make the hex part 2" long. The 9/16" portion is machined to 7/16 diameter and threaded to fit the knurled nut on the sensor.Measure the threads inside the nut to determine proper thread size.Since this is a dry sensor, the inside of the accessory nut is hollow and the sensor slips easily into it. The unit is cadmium plated.Hope this helps. Have fun! Paul
|