Posted by Mike Flanagan on September 18, 1997 at 20:28:12
In Reply to: How do you adjust the float in a Zenith-2 Carburetor?
posted by Ken Smith on September 18, 1997 at 19:32:02
Ken, with the carb on the car remove the bottom of the carb. The top of the float should be 5/8 inch from the bottom mateing edge of the upper carb half when held in the up position with your finger. I use a 5/8 open inch wrench for a sight guide. This does not guarantee that the fuel level in the float bowl will be right. You need a sight gauge for that. God speed under 50. The Model A Fool. |