Need '31 AA Transmission Gear

Posted by Joe Biller on June 09, 1997 at 01:57:12

I'm close to finishing my 31 Fire Engine.... discovered the gear that slides on the output shaft splines.... outside the transmission case....is worn in the middle. It is about 3 to 4 inches in diameter and is held onto the output shaft with a bolt and a special washer..... This gear couples to the intermediate jack shaft that has the "U" joint assembly at the opposit end..... Any help???? jsbiller@whidbey.net



Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam