: Just completed my 30 Coupe, and I'm ready to take the "test drive".Does anyone out there know of a good way to adjust the toe-in of the front tires?I am assuming my axle and other components are to factory specifications. (Yeah, I know, that's like "Military Intelligence").Thanks.. Larry - One further hint to make measuring toe-in more accurate.I do it like Dan, but with front wheels raised off the ground, I wrap a wide piece of masking tape around each tire in the center of the tread, then spin the tire and mark a line with a pencil while spinning.This gives you a good reference line to measure from and is easier to see than a mark on the tread.If you measure from tread lines it won't be accurate as tread is seldom concentric (it wobbles slightly as the tire is spun).I also make a little gauge to mark points at the front and back of each tire which are the same distance from the ground - of course the car is off the jackstands when the measurements are made.Good luck!
|