Posted by Jim McPherson on April 10, 1997 at 22:49:43
In Reply to: 29 two-tooth steering
posted by John Bowne on April 10, 1997 at 20:58:58
: I have an early 29 two-tooth steering gear that needs a lower roller bearing cup.The worm is fine, but the rollers are cylindrical, not tapered like the wheel bearings.Consequently the existing cup has a 27 degree angle to the centerline, which ismuch greater than other tapered roller bearings I have found.Does anyone know where to find a replacement cup. John, This is the same cup and rlooer bearing used in the 30-31 two-tooth sector. Any parts house should have it. Good luck. Jim |