Posted by Bob Carabbio on April 06, 1997 at 18:49:45
In Reply to: clutch release bearing lubrication
posted by Wayne Parker on April 04, 1997 at 00:11:40
The repro bearings are advertised as permanently lubricated. The grease fitting feeds directly into the bore of the throwout sleeve, and did communicate grease to the throwout bearing thru 4 holes in the sleeve which are now blocked by the new bearing.Since now all you're doing is lubricating the sliding sleeve which is essentially stationary, a coat of Lubriplate on the inside of the sleeve at assembly, or 1/2 pump of lithium grease in the fitting should hold you for several years. |