Posted by Steve Smith on April 02, 1997 at 11:29:57
In Reply to: 31 Generator
posted by Dean Travis on April 02, 1997 at 10:04:50
: I'm trying to assemble a generator that came in a box dissassembled with my car. I have two back covers! Both fit the armature correctly! The armature usesa standard 31 generator rear end plate bushing(non bearing type) consistent with a 31 generator! My question is that one rear end plate has round holes in it and the other does not! I figure the holes were probly for cooling! The rear end plate also seems to made out of a white metal versis steel! The other cover does not seem to fit the generator body very good so I figure it probly doesn't go with car!Which rear cover is correct? The stamped steel without the holes is the correct one |