Re: Lower Cowl Brackets

Posted by Bob Carabbio on February 26, 1997 at 23:26:58

In Reply to: Re: Lower Cowl Brackets
posted by Dean Travis on February 21, 1997 at 19:58:51

Yeah - I see what you mean.I assume that these are part of the sub-frame extention pieces.However, they do look simple enough to fabricate.Mine are pin-holed, but still structurally O.K.I'll Repair mine with Braze whenever I get the outer skin off.If you drill out the rivets, they should be removable allowing you to make a reasonable facimile out of 16-18 Ga steel.

E-Mail Comment to Webmaster